Average Maytag dryer repair cost?

Most Maytag dryer repairs in the Twin Cities land $225–$385 all-in — parts, labor, and the $149 trip fee (which is credited toward the repair when you approve the work). Sealed-system or compressor work runs higher and we always quote that up front. Every job ships with a 1-year written parts-and-labor warranty.

Is Maytag the same as Whirlpool inside?

Mostly yes — top-load Bravos / Centennial share the VMW platform with Whirlpool Cabrio, and Maxima shares the Duet platform. Parts cross-reference and pricing tracks within $20–$40.

Why does my thermal fuse keep blowing?

Almost always a restricted vent — the dryer over-temps, blows the fuse to protect itself, you replace the fuse without clearing the vent, it blows again. We check airflow on every no-heat call.

Is it worth fixing a 10-year-old Maytag dryer?

Under $400, almost always yes. A new comparable Maytag runs $850–$1,100 — a $300 belt-and-roller job buys 4–5 more years easily on a well-maintained unit.

Do you service gas Maytags?

Yes — Maytag dryer repair service runs across the Twin Cities every weekday, including condos, townhomes, single-family, and small commercial. There's no separate trip charge by neighborhood or ZIP inside the city limits. Property managers and landlords welcome; we handle COI and split-billing on request.

The $149 flat trip fee is credited toward the repair the moment you approve the work, so on any approved dryer repair job in the Twin Cities it effectively disappears into the total. Decline the repair and the $149 covers the in-home visit, full diagnostic, and a written failure analysis you can use elsewhere.

MAYTAG DRYER · REPAIR COST

Maytag Dryer Repair Cost 2026 Twin Cities Pricing by Part & Symptom

Maytag dryers are built on the Whirlpool VMW (top-load Bravos / Centennial) and Duet (front-load Maxima) platforms, so failure patterns and pricing track the equivalent Whirlpool unit closely. The thermal fuse + vent combo accounts for almost half of Twin Cities Maytag dryer calls — when we replace the fuse without clearing the vent, it blows again within a week, so vent inspection is included on every no-heat visit. Pricing below covers parts, labor, and the $149 trip fee (waived on approval).

4.5★ · 990+
1-Yr Warranty
OEM Parts
Same-Day

(651) 364-7466

$149Trip feeWaived on repair

See brands we service

Same-day windows
Call before 2pm for today's route.
Every Minneapolis ZIP
55401–55455. No trip charge.
EPA 608 certified
Sealed-system & refrigerant work.
1-year warranty
Parts and labor in writing.

Updated June 21, 2026 · Pricing reviewed quarterly

Quick answer

Maytag Dryer Repair — Twin Cities — Quick Answer

See the full Minneapolis appliance repair service area for neighborhoods, ZIPs, and same-day availability.

What we fix in Minneapolis

The Minneapolis repair mix

Not heating — $245–$385

On electric Maytags, 8 out of 10 no-heat calls trace to a tripped thermal fuse or a burned-out element — both are downstream of restricted venting. We check the vent run with an anemometer before condemning the element so the new part doesn't fail in a week. On gas Maytags (Bravos XL gas, Maxima gas) it's the igniter, flame sensor, or gas valve coil — $245–$385 installed.

Loud noise (rumble / squeal / thump) — $245–$345

Idler pulley, drive belt, and drum rollers wear as a set on the VMW platform — replacing only the squealing part means another visit in 6–9 months. Our flat $245–$345 covers all three so the next failure isn't on us.

Won't tumble / motor hums — $345–$485

Either a snapped belt (bottom of the range) or a seized blower wheel / drive motor (top of the range). Bravos XL units throw a long-tumble bearing wear that shows up as motor groan before full failure — easier to catch early.

Won't start / door switch / control — $185–$585

Door switch failures are the cheap end ($185–$245). The main control board on Maxima front-loads is the expensive end ($385–$585) — we verify wiring harness and door lock before condemning the board.

Vent cleaning + verification — $185–$245

Bagged from the dryer through the wall cap, with airflow measurement before and after. A blocked vent is the #1 cause of repeat thermal-fuse failures and shortens dryer life by years. Often booked alongside a no-heat repair at a combined rate.

Models we work most

Maytag Bravos MEDB / MGDB (electric / gas top-load), Centennial MEDC / MGDC, Maxima MED / MGD front-load, Performance MED / MGD, and the Maytag Commercial MDE / MDG. We carry the OEM parts kits for all five platforms on the truck.

From the truck

Field-service notes on dryer repair

On dryer repair, we keep the diagnostic tight because the failure catalog on this brand is well-documented. Minneapolis water hardness runs 8–15 grains per gallon depending on your source, which chews through steam-generator elements, valve seats, and dishwasher heating elements faster than the spec sheet assumes.

Because this page focuses on not heating — $245–$385, our tech opens the call by isolating that subsystem before touching anything else. Wear parts (belts, pumps, igniters, valves) ship from our truck stock; boards and sealed-system parts are OEM-only from Marcone or the manufacturer's direct distributor. The $149 residential diagnostic is credited toward the repair if you approve; if you don't, you pay only the diagnostic and we leave a written scope. Every completed repair carries a 1-year parts and labor warranty in writing. The section above covers the specific failure surface — on electric maytags, 8 out of 10 no-heat calls trace to a tripped thermal fuse or a burned-out element — both are downstream of restricted venting.

We stock the top-30 wear items for this brand on the truck, so most first-visit repairs close same-day. We're EPA 608 certified for sealed-system and refrigerant work, licensed and insured in Minnesota, and every tech carries a factory diagnostic laptop for brand-specific service modes. If the model is out of parts support, we'll say so on the first call and refund the diagnostic — that's the honest read on a repair-vs-replace decision, and it's the same read we'd give a family member calling about the same dryer.

Comparison

Maytag Dryer Repair Cost by part (2026)

All-in pricing — OEM parts, labor, 1-year written warranty. $149 trip fee waived when you approve the repair.

Part / repair	All-in cost
Heating element	$245–$385
Thermal fuse / hi-limit	$185–$245
Idler + belt	$245–$345
Drum rollers	$245–$345
Door switch	$185–$245
Control board	$385–$585
Vent cleaning	$185–$245

Coverage

Minneapolis neighborhoods we cover

Same-day service routes through every Minneapolis ZIP — no separate trip charge anywhere inside city limits.

Neighborhood deep-dives

Neighborhoods

Uptown
Northeast Minneapolis
Downtown
North Loop
Mill District
Powderhorn
Longfellow
Linden Hills
Kingfield
Lyn-Lake
Lyndale
Whittier
Loring Park
Cedar-Riverside
Marcy-Holmes
Como
Phillips
Standish-Ericsson
Seward
Prospect Park
Nokomis
Bryn Mawr
Fulton
Tangletown
Armatage
Windom
Diamond Lake
Audubon Park
Sheridan
St. Anthony East
St. Anthony West
Logan Park
Holland
Columbia Park
Waite Park
Webber-Camden
Folwell
Jordan
Hawthorne
Near North
Harrison
Cedar-Isles-Dean
East Isles
ECCO
Lowry Hill
Lowry Hill East
Stevens Square
Elliot Park
Kenwood
Lake of the Isles
Lake Harriet
Lake Calhoun / Bde Maka Ska

ZIP codes

55401, 55402, 55403, 55404, 55405, 55406, 55407, 55408, 55409, 55410, 55411, 55412, 55413, 55414, 55415, 55416, 55417, 55418, 55419, 55454, 55455

Response windows

Drive times from our Minneapolis hub

Same-day windows are based on truck position at the time you call. The matrix below reflects typical mid-day response from our 222 E Hennepin hub.

City	Drive time	Same-day cutoff
Minneapolis (city)	0–20 min	Daily, call before 2pm
St. Paul	15–25 min	Daily, call before 2pm
Edina	15–20 min	Daily, call before 2pm
Bloomington	20–25 min	Daily, call before 1pm
Eden Prairie	20–30 min	Daily, call before 1pm
Maple Grove	20–30 min	Daily, call before 1pm
Plymouth	20–25 min	Daily, call before 1pm
Roseville	15–20 min	Daily, call before 2pm
Woodbury	25–35 min	Daily, call before 12pm
Golden Valley	10–15 min	Daily, call before 2pm

FAQ

Minneapolis questions, answered

Average Maytag dryer repair cost?
Most Maytag dryer repairs in the Twin Cities land $225–$385 all-in — parts, labor, and the $149 trip fee (which is credited toward the repair when you approve the work). Sealed-system or compressor work runs higher and we always quote that up front. Every job ships with a 1-year written parts-and-labor warranty.
Is Maytag the same as Whirlpool inside?
Mostly yes — top-load Bravos / Centennial share the VMW platform with Whirlpool Cabrio, and Maxima shares the Duet platform. Parts cross-reference and pricing tracks within $20–$40.
Why does my thermal fuse keep blowing?
Almost always a restricted vent — the dryer over-temps, blows the fuse to protect itself, you replace the fuse without clearing the vent, it blows again. We check airflow on every no-heat call.
Is it worth fixing a 10-year-old Maytag dryer?
Under $400, almost always yes. A new comparable Maytag runs $850–$1,100 — a $300 belt-and-roller job buys 4–5 more years easily on a well-maintained unit.
Do you service gas Maytags?
Yes — Maytag dryer repair service runs across the Twin Cities every weekday, including condos, townhomes, single-family, and small commercial. There's no separate trip charge by neighborhood or ZIP inside the city limits. Property managers and landlords welcome; we handle COI and split-billing on request.
Diagnostic fee?
The $149 flat trip fee is credited toward the repair the moment you approve the work, so on any approved dryer repair job in the Twin Cities it effectively disappears into the total. Decline the repair and the $149 covers the in-home visit, full diagnostic, and a written failure analysis you can use elsewhere.

Related Minneapolis repair pages

Need fridge repair? See our Minneapolis page

Same-day refrigerator repair in Minneapolis — Sub-Zero, Samsung, LG, Whirlpool, KitchenAid. Flat $149 trip fee waived with repair, 1-year warranty on parts and labor.

Book dryer repair in Minneapolis

Have your model and serial number handy. Call before 2pm and we'll usually have a same-day window across Minneapolis.

(651) 364-7466Contact us →

Brands we service in Minneapolis

Dedicated Minneapolis landing pages for each brand we run most — fault codes, pricing, and the OEM parts our trucks stock for Minneapolis homes.