DISHWASHER COMPONENTS · MINNEAPOLIS

Dishwasher Control Board & Component Repair in Minneapolis, MN

Dishwasher failures cluster around five parts: control board (no power, wrong cycles), drain pump (E24/E25), circulation motor (poor cleaning), water-inlet valve (won't fill), and float switch (overfill / leak protect). We carry OEM parts for Bosch, KitchenAid, Whirlpool, Samsung, GE, and Miele on every truck.

  • 4.5★ · 990+
  • 1-Yr Warranty
  • OEM Parts
  • Same-Day
(651) 364-7466
$149Trip feeWaived on repair
See brands we service
  • Same-day windows

    Call before 2pm for today's route.

  • Every Minneapolis ZIP

    55401–55455. No trip charge.

  • EPA 608 certified

    Sealed-system & refrigerant work.

  • 1-year warranty

    Parts and labor in writing.

Updated June 23, 2026

Quick answer

Dishwasher Control Board & Component Repair in Minneapolis, MN — Quick Answer

Browse the Minneapolis appliance repair hub for pricing, brands, and the full neighborhood list.

What we fix in Minneapolis

The Minneapolis repair mix

Control board — won't start, wrong cycles, display dead

Bosch, KitchenAid, and Whirlpool boards fail from cabinet heat and moisture. We test 120V supply and door-latch signal before condemning the board.

Drain pump — E24, E25, water left in tub

Bosch E24/E25 = drain restriction or failed pump. We clear the check-valve, drain hose, and air-gap before swapping the pump.

Water inlet valve — won't fill

Single-coil valve, $185–$285 installed. Hard-water scale in Minneapolis (17 gpg) shortens valve life by 30–40%.

Float switch & flood-protect

Float-switch failure causes overfill leaks or false 'no fill' faults. We test continuity in both float positions.

Circulation motor & wash impeller

Bosch heats via the circulation pump; impeller wear = poor cleaning. KitchenAid/Whirlpool use separate wash motors.

From the truck

Field-service notes on dishwasher component repair

Dishwasher Component Repair in the Twin Cities has its own rhythm — a repeating set of failures we see week after week. Older Twin Cities housing stock (pre-1970 Kenwood, Como, Highland Park, Northeast) frequently has 15A dedicated circuits feeding modern 20A-rated appliances, which shows up as intermittent shutdowns misread as control-board failure.

Because this page focuses on control board — won't start, wrong cycles, display dead, our tech opens the call by isolating that subsystem before touching anything else. OEM parts get sourced from Marcone, Reliable Parts, and 1st Source — never Amazon or eBay for anything sealed-system, control, or safety-critical. The $149 residential diagnostic is credited toward the repair if you approve; if you don't, you pay only the diagnostic and we leave a written scope. Every completed repair carries a 1-year parts and labor warranty in writing. The section above covers the specific failure surface — bosch, kitchenaid, and whirlpool boards fail from cabinet heat and moisture.

Most first-visit calls close same-day for common failure modes; parts-return trips are typically 2–4 business days when we need a factory-only component. We're EPA 608 certified for sealed-system and refrigerant work, licensed and insured in Minnesota, and every tech carries a factory diagnostic laptop for brand-specific service modes. If the model is out of parts support, we'll say so on the first call and refund the diagnostic — that's the honest read on a repair-vs-replace decision, and it's the same read we'd give a family member calling about the same dishwasher component.

FAQ

Minneapolis questions, answered

  • How much does dishwasher control board repair cost in Minneapolis?

    Most dishwasher component repairs in Minneapolis land $385–$585 all-in — parts, labor, and the $149 trip fee (which is credited toward the repair when you approve the work). Sealed-system or compressor work runs higher and we always quote that up front. Every job ships with a 1-year written parts-and-labor warranty.

  • Drain pump cost?

    Most dishwasher component repairs in Minneapolis land $245–$345 all-in — parts, labor, and the $149 trip fee (which is credited toward the repair when you approve the work). Sealed-system or compressor work runs higher and we always quote that up front. Every job ships with a 1-year written parts-and-labor warranty.

  • Is it worth fixing a 7-year-old dishwasher?

    Bosch 800/Benchmark, KitchenAid, Miele: yes. Builder-grade Whirlpool/GE: depends on the part cost vs. replacement.

  • Same-day component service?

    Same-day windows are typical for dishwasher component repair calls in Minneapolis when you book before 2pm — our trucks already run the metro daily. Later in the day usually means a next-business-morning slot. We confirm a 2-hour window the morning of the visit and call when the tech is 20 minutes out.

  • Warranty?

    Yes — every appliance dishwasher component repair repair we complete in Minneapolis carries a 1-year written parts-and-labor warranty at no extra charge. It's printed on the invoice, not buried in a separate purchase. If the same failure recurs inside the warranty window we come back free, replace the part, and re-test.

Book dishwasher component repair in Minneapolis

Have your model and serial number handy. Call before 2pm and we'll usually have a same-day window across Minneapolis.

Brands we service in Minneapolis

Dedicated Minneapolis landing pages for each brand we run most — fault codes, pricing, and the OEM parts our trucks stock for Minneapolis homes.