Do you service gas dryers in Minneapolis?

Yes — dryer repair service runs across Minneapolis every weekday, including condos, townhomes, single-family, and small commercial. There's no separate trip charge by neighborhood or ZIP inside the city limits. Property managers and landlords welcome; we handle COI and split-billing on request.

How much does a gas-dryer repair cost?

Most dryer repairs in Minneapolis land $215–$365 all-in — parts, labor, and the $149 trip fee (which is credited toward the repair when you approve the work). Sealed-system or compressor work runs higher and we always quote that up front. Every job ships with a 1-year written parts-and-labor warranty.

Is gas safety included?

Yes — electronic leak-detector check at the supply, valve, and burner on every gas-dryer call. No extra charge.

Same-day windows are typical for dryer repair calls in Minneapolis when you book before 2pm — our trucks already run the metro daily. Later in the day usually means a next-business-morning slot. We confirm a 2-hour window the morning of the visit and call when the tech is 20 minutes out.

Will you check the vent too?

Yes — vent inspection on every visit. Lint-clogged vents are the #1 cause of premature igniter failure. We tell you honestly if the vent is the real problem.

GAS DRYER · MINNEAPOLIS

Gas Dryer Repair in Minneapolis, MN

Gas dryer not heating in Minneapolis? 90% of these calls are one of three parts: the glow-bar igniter, the dual gas-valve coils, or the flame-sensor (radiant-sensor) thermostat. We carry all three for Whirlpool, Maytag, LG, Samsung, GE, and Kenmore on every truck — and the vent inspection that should always go with it.

4.5★ · 990+
1-Yr Warranty
OEM Parts
Same-Day

(651) 364-7466

$149Trip feeWaived on repair

See brands we service

Same-day windows
Call before 2pm for today's route.
Every Minneapolis ZIP
55401–55455. No trip charge.
EPA 608 certified
Sealed-system & refrigerant work.
1-year warranty
Parts and labor in writing.

Updated June 23, 2026

Quick answer

Gas Dryer Repair in Minneapolis, MN — Quick Answer

Looking for the broader appliance repair Minneapolis hub? It covers every ZIP, brand, and appliance we service.

What we fix in Minneapolis

The Minneapolis repair mix

No-heat diagnostic — what we test in order

1) Igniter glow-and-drop test. 2) Gas-valve coil resistance. 3) Flame-sensor continuity at room temp. 4) Thermal-fuse and high-limit thermostat. 5) Vent restriction (the cause of most premature failures).

Vent inspection — included on every visit

Long flexible-foil vent runs pack with lint, kill airflow, and burn out heating components on a 2-year cycle. We inspect on every visit and clean when needed. If the issue is purely the vent, we tell you that instead of selling parts.

Gas safety check — included

Every gas-dryer repair includes an electronic leak-detector check at the supply, valve, and burner connections. No extra charge. Gas supply pressure tested before condemning igniter or valve.

Common Minneapolis gas-dryer faults

Older Kenmore and GE 1990s–2000s gas dryers in Linden Hills, Tangletown, and Fulton ramblers — glow-bar igniter degradation. Newer LG/Samsung — control-board relay failures masquerading as no-heat. Whirlpool/Maytag — thermal-fuse trips driven by vent restriction.

From the truck

Field-service notes on dryer repair

Dryer Repair in the Twin Cities has its own rhythm — a repeating set of failures we see week after week. Older Twin Cities housing stock (pre-1970 Kenwood, Como, Highland Park, Northeast) frequently has 15A dedicated circuits feeding modern 20A-rated appliances, which shows up as intermittent shutdowns misread as control-board failure.

Because this page focuses on no-heat diagnostic — what we test in order, our tech opens the call by isolating that subsystem before touching anything else. OEM parts get sourced from Marcone, Reliable Parts, and 1st Source — never Amazon or eBay for anything sealed-system, control, or safety-critical. The $149 residential diagnostic is credited toward the repair if you approve; if you don't, you pay only the diagnostic and we leave a written scope. Every completed repair carries a 1-year parts and labor warranty in writing. The section above covers the specific failure surface — 1) igniter glow-and-drop test.

Most first-visit calls close same-day for common failure modes; parts-return trips are typically 2–4 business days when we need a factory-only component. We're EPA 608 certified for sealed-system and refrigerant work, licensed and insured in Minnesota, and every tech carries a factory diagnostic laptop for brand-specific service modes. If the model is out of parts support, we'll say so on the first call and refund the diagnostic — that's the honest read on a repair-vs-replace decision, and it's the same read we'd give a family member calling about the same dryer.

FAQ

Minneapolis questions, answered

Do you service gas dryers in Minneapolis?
Yes — dryer repair service runs across Minneapolis every weekday, including condos, townhomes, single-family, and small commercial. There's no separate trip charge by neighborhood or ZIP inside the city limits. Property managers and landlords welcome; we handle COI and split-billing on request.
How much does a gas-dryer repair cost?
Most dryer repairs in Minneapolis land $215–$365 all-in — parts, labor, and the $149 trip fee (which is credited toward the repair when you approve the work). Sealed-system or compressor work runs higher and we always quote that up front. Every job ships with a 1-year written parts-and-labor warranty.
Is gas safety included?
Yes — electronic leak-detector check at the supply, valve, and burner on every gas-dryer call. No extra charge.
Same-day service?
Same-day windows are typical for dryer repair calls in Minneapolis when you book before 2pm — our trucks already run the metro daily. Later in the day usually means a next-business-morning slot. We confirm a 2-hour window the morning of the visit and call when the tech is 20 minutes out.
Will you check the vent too?
Yes — vent inspection on every visit. Lint-clogged vents are the #1 cause of premature igniter failure. We tell you honestly if the vent is the real problem.

Related Minneapolis repair pages

Book dryer repair in Minneapolis

Have your model and serial number handy. Call before 2pm and we'll usually have a same-day window across Minneapolis.

(651) 364-7466Contact us →

Brands we service in Minneapolis

Dedicated Minneapolis landing pages for each brand we run most — fault codes, pricing, and the OEM parts our trucks stock for Minneapolis homes.