Why is my dryer not heating?

5 causes account for almost every case — listed above by frequency. Without an in-home test we can't tell you which one is yours, but we can tell you what we'd check first.

Can I fix this myself?

Sometimes. If it's a coin in the drain pump, a clogged dryer vent, or a knockout plug on a new dishwasher — yes. If it's a sealed system, a control board, or a gas safety component — no. We'd rather you DIY the easy ones.

How much will it cost to repair?

Flat $149 trip fee ($149 for refrigeration), waived when you approve the repair. Most dryer repairs land $225–$525 all-in. We give you a written quote before any work.

How fast can you come out?

Same-day windows weekdays when you call before 2pm. Otherwise next business day. We cover every Minneapolis ZIP — no extra trip charge anywhere inside city limits.

Do you stock the common parts?

Yes — for dryers, that's drain pumps, door boots, heating elements, thermistors, igniters, control-board common SKUs, and OEM gaskets. About 80% of these calls finish first visit.

What if repair doesn't make sense?

We tell you straight. If the repair is over 50% of replacement on an appliance past year 10, we recommend replacement and the $149 still applies for the honest answer.

How fast can you get to my dryer no-heat calls in Minneapolis?

Same-day windows weekdays when you call before 2pm, otherwise next-business-day. We route every ZIP 55401–55455 from our Edina-area hub. No trip charge inside city limits.

Are you licensed and insured for appliance repair in Minneapolis?

Yes — fully licensed, insured, and EPA 608 certified for sealed-system refrigeration work required by Minneapolis. All work backed in writing with a 1-year parts + labor warranty.

TROUBLESHOOT · MINNEAPOLIS

Dryer Not Heating? We Fix It Same-Day in Minneapolis

A dryer that tumbles but won't heat is almost always one of three parts: a blown thermal fuse (gas and electric), a failed heating element (electric), or a bad igniter / flame sensor (gas). On Minneapolis calls, lint-clogged vent runs are the underlying cause more than half the time — they cook the thermal fuse, then the new fuse blows again within a week if the vent isn't cleared. We test the venting on every no-heat call before quoting parts.

4.5★ · 990+
1-Yr Warranty
OEM Parts
Same-Day

(651) 364-7466

$149Trip feeWaived on repair

See brands we service

Same-day windows
Call before 2pm for today's route.
Every Minneapolis ZIP
55401–55455. No trip charge.
EPA 608 certified
Sealed-system & refrigerant work.
1-year warranty
Parts and labor in writing.

Updated June 9, 2026 · Reviewed by service manager

Quick answer

Dryer not heating repair in Minneapolis — Quick Answer

Part of our Minneapolis appliance repair coverage — same-day windows across every Mpls ZIP.

What we fix in Minneapolis

The Minneapolis repair mix

Thermal fuse blown from a clogged vent

Most common in older Minneapolis homes with long basement vent runs. Replace the fuse, but also clean the vent — or it pops again in a month.

Heating element failure (electric)

Coil break inside the element housing. Multimeter test confirms. Common on dryers past year 8.

Igniter failed (gas)

Glow-bar igniter wears out. We test the ignition sequence — igniter glows but won't fire = bad flame sensor, not the igniter.

Cycling thermostat / hi-limit

These trip from overheating (almost always vent restriction). Same fix story as the thermal fuse.

Bad timer / control board

Rare. We rule out everything else first because boards are the most expensive part on the dryer.

Field notes from Minneapolis

Across dryer no-heat calls in Minneapolis, two patterns drive the volume: 1.5-story homes in Linden Hills, Fulton, Tangletown, and Lyn-Lake with long appliance vent / drain runs that fail earlier than newer construction; and Northeast bungalows / Powderhorn / Longfellow rentals where original 1980s wiring and supply lines push fittings past spec. Our route covers every ZIP 55401–55455 the same day when you call before 2pm weekdays — no extra trip charge anywhere inside city limits. We stock OEM parts truck-side for every common Whirlpool, Maytag, Kenmore, KitchenAid, GE, Samsung, LG, Frigidaire, and Bosch platform — about 88% of Minneapolis service calls finish first visit.

From the truck

Field-service notes on dryer repair

Dryer Repair in the Twin Cities has its own rhythm — a repeating set of failures we see week after week. Minneapolis water hardness runs 8–15 grains per gallon depending on your source, which chews through steam-generator elements, valve seats, and dishwasher heating elements faster than the spec sheet assumes.

Because this page focuses on thermal fuse blown from a clogged vent, our tech opens the call by isolating that subsystem before touching anything else. For anything that touches refrigerant, sealed-system, or a gas train, we run OEM parts from Marcone or the factory distributor — aftermarket boards in particular are a warranty landmine we won't ship on our truck. The $149 residential diagnostic is credited toward the repair if you approve; if you don't, you pay only the diagnostic and we leave a written scope. Every completed repair carries a 1-year parts and labor warranty in writing. The section above covers the specific failure surface — most common in older minneapolis homes with long basement vent runs.

Most first-visit calls close same-day for common failure modes; parts-return trips are typically 2–4 business days when we need a factory-only component. We're EPA 608 certified for sealed-system and refrigerant work, licensed and insured in Minnesota, and every tech carries a factory diagnostic laptop for brand-specific service modes. If the model is out of parts support, we'll say so on the first call and refund the diagnostic — that's the honest read on a repair-vs-replace decision, and it's the same read we'd give a family member calling about the same dryer.

FAQ

Minneapolis questions, answered

Why is my dryer not heating?
5 causes account for almost every case — listed above by frequency. Without an in-home test we can't tell you which one is yours, but we can tell you what we'd check first.
Can I fix this myself?
Sometimes. If it's a coin in the drain pump, a clogged dryer vent, or a knockout plug on a new dishwasher — yes. If it's a sealed system, a control board, or a gas safety component — no. We'd rather you DIY the easy ones.
How much will it cost to repair?
Flat $149 trip fee ($149 for refrigeration), waived when you approve the repair. Most dryer repairs land $225–$525 all-in. We give you a written quote before any work.
How fast can you come out?
Same-day windows weekdays when you call before 2pm. Otherwise next business day. We cover every Minneapolis ZIP — no extra trip charge anywhere inside city limits.
Do you stock the common parts?
Yes — for dryers, that's drain pumps, door boots, heating elements, thermistors, igniters, control-board common SKUs, and OEM gaskets. About 80% of these calls finish first visit.
What if repair doesn't make sense?
We tell you straight. If the repair is over 50% of replacement on an appliance past year 10, we recommend replacement and the $149 still applies for the honest answer.
How fast can you get to my dryer no-heat calls in Minneapolis?
Same-day windows weekdays when you call before 2pm, otherwise next-business-day. We route every ZIP 55401–55455 from our Edina-area hub. No trip charge inside city limits.
Are you licensed and insured for appliance repair in Minneapolis?
Yes — fully licensed, insured, and EPA 608 certified for sealed-system refrigeration work required by Minneapolis. All work backed in writing with a 1-year parts + labor warranty.

Related Minneapolis repair pages

What will this cost?

Pricing & repair-cost pages

Trying to decide repair vs. replace? These pages break down real all-in Twin Cities pricing by brand, model class, and failure mode.

Book dryer repair in Minneapolis

Have your model and serial number handy. Call before 2pm and we'll usually have a same-day window across Minneapolis.

(651) 364-7466Contact us →

Brands we service in Minneapolis

Dedicated Minneapolis landing pages for each brand we run most — fault codes, pricing, and the OEM parts our trucks stock for Minneapolis homes.