MAYTAG ICE MAKER · TWIN CITIES

Maytag Ice Maker Repair Twin Cities Same-Day

Maytag French-door (MFI, MFT), side-by-side (MSS, MSF), and bottom-freezer refrigerators use the Whirlpool-built modular icemaker — the same family as Whirlpool, KitchenAid, JennAir, and Amana. We carry every common OEM part on the truck. Part of our full Maytag appliance repair coverage and our Twin Cities ice maker repair service.

  • 4.5★ · 990+
  • 1-Yr Warranty
  • OEM Parts
  • Same-Day
(651) 364-7466
$149Trip feeWaived on repair
See brands we service
  • Same-day windows

    Call before 2pm weekdays.

  • OEM Maytag parts

    Modules, valves, harnesses stocked.

  • 1-year warranty

    Parts and labor in writing.

  • $149 trip fee

    Fully waived with repair.

Quick answer

Maytag ice maker — Quick answer

Most Maytag ice maker repairs land $185–$365 all-in. The flat $149 fridge trip fee is waived when you approve the repair. About 9 in 10 Maytag icemaker calls trace back to one of three parts — inlet valve, fill tube, or the modular icemaker itself — and finish in a single visit.

Maytag ice maker failures

What goes wrong on Maytag ice makers

Maytag ice maker not making ice (most common)

Most common cause: Frozen fill tube caused by a slow-closing water inlet valve dribbling after the fill is done — water freezes in the tube and blocks the next fill. The icemaker still cycles audibly but no new cubes drop.

What we do: Thaw the fill tube, leak-test the inlet valve, replace the OEM dual-coil valve if it drips when closed. Force two harvest cycles before closing the call.

$215–$345 all-in

Maytag ice maker dead — no cycle, no sound

Most common cause: Failed modular icemaker (W10882923 / W10190961 / 4317943 generations) — internal harvest motor or fill thermostat failed. Test points on the module plug confirm.

What we do: Replace the OEM modular icemaker, verify a full harvest within 60 minutes of install.

$245–$345 all-in

Maytag ice maker leaking into the freezer drawer

Most common cause: Cracked / split fill tube from repeated freeze cycles, failed inlet-valve diaphragm letting water through when commanded closed, or a drifted fill thermostat over-filling the mold.

What we do: Replace the OEM fill tube and inlet valve; swap the modular icemaker if the fill thermostat is reading out of spec.

$215–$345 all-in

Maytag ice maker producing hollow or small cubes

Most common cause: Partial fill — frozen fill tube, weak inlet valve flow, low household pressure (<20 psi), or an overdue water filter restricting flow.

What we do: Replace the filter, verify line psi, thaw fill tube, swap inlet valve if flow is below spec.

$185–$285 all-in

Ice maker stopped after defrost or moving food

Most common cause: Wire shutoff arm got bumped UP into the OFF position. Not a failure — but a real call we get weekly.

What we do: Push the shutoff arm DOWN and wait 24 hours for a full harvest. If still no ice it's likely the valve or module.

Free fix (call first)

Error codes

Maytag ice maker error codes

CodeMeaning
POPower outage notice on display — informational
ICE OFF (flashing)Icemaker disabled via control — hold ICE 3 seconds to re-enable
E2 / E3Modular icemaker fault — replace modular unit
F8Water fill fault — inlet valve or supply pressure issue
SbSabbath mode disables icemaker; hold OPTIONS to exit
Filter LEDWater filter past 6 months — replace before further icemaker diagnosis

Coverage

Maytag ice maker repair near you

We dispatch from the Twin Cities daily — same flat $149 trip fee across every city we serve.

FAQs

Maytag ice maker repair — common questions

How much does Maytag ice maker repair cost in Minneapolis?

Most Maytag ice maker repairs are $185–$365 all-in (parts + labor + $149 trip fee, credited to the repair). Modular icemaker swaps run $245–$345; inlet valve / fill tube jobs $215–$305.

Why won't my Maytag ice maker make ice but the water dispenser works?

The water and ice circuits use separate solenoids on the dual-coil inlet valve. The water side can work while the ice side has failed open or the fill tube is frozen. We pressure-test both circuits on every call.

Do Maytag and Whirlpool ice makers use the same parts?

Yes — Maytag, Whirlpool, KitchenAid (freestanding), JennAir, and Amana all use the same Whirlpool-built modular icemaker (commonly 4317943 → W10190961 → W10882923) on French-door and side-by-side units. Parts are fully cross-compatible.

How long does Maytag ice maker repair take?

60–75 minutes on most modular icemaker swaps and inlet-valve jobs. About 90% of Maytag ice maker calls finish on the first visit because we stock every common part.

Do you carry OEM Maytag ice maker parts on the truck?

Yes — modular icemakers, dual-coil inlet valves, fill tubes, shutoff arms, and dispenser augers for MFI, MFT, MSS, MSF, MBR, MBL series. OEM Maytag / Whirlpool only; any equivalent disclosed in writing.

Is a Maytag ice maker worth repairing?

Almost always yes — Maytag icemaker repairs are cheap relative to the fridge value. Even on a 10-year-old Maytag French-door, a $260 ice maker repair pencils out compared to $2,400+ for replacement.

Do you service Maytag bottom-freezer and side-by-side models?

Yes — every Maytag refrigerator configuration (French-door MFI/MFT, side-by-side MSS/MSF, bottom-freezer MBR/MBL) shares the same modular icemaker design and is serviced same-day across the Twin Cities.

Do you warranty Maytag ice maker repairs?

Yes — 1-year written parts-and-labor warranty on every repair. Same failure within 12 months = we come back free.